To eliminate bosses rapidly with the Saw Ball in BALL x PIT, you must maximize its multi-hit collision rate and pin the target against an arena boundary. Unlike standard impact ammunition that deflects immediately upon contact, the Saw Ball deals continuous damage for every frame it overlaps an enemy's hitbox. Combining high projectile velocity with tight wall rebounds bypasses extended boss phases before summons or defensive mechanics trigger.

How the Saw Ball Collision Model Works

Standard projectiles like the Iron Ball and Bomb Ball deliver single-instance burst damage before bouncing backward into the pit. While effective for pinging between scattered minion waves, this rebound delay caps single-target damage against bosses.

The Saw Ball does not bounce off targets instantly. Instead, it drills directly through or grinds along the perimeter of wide boss hitboxes. Because each active tick inside the target registers a separate damage calculation, sustained contact delivers dozens of hits in fractions of a second.

In-Run Stat Priorities

To optimize the Saw Ball, prioritize stats that sustain momentum and increase the frequency of hit calculations rather than focusing solely on raw power.

StatPriorityPrimary Benefit
Projectile VelocityCorePrevents speed loss upon impact and accelerates bounce cycles.
Tick FrequencyCoreMultiplies the number of damage ticks registered per second.
Hitbox PenetrationSecondaryExtends the duration the ball remains embedded in dense targets.
Flat Damage / PowerSecondaryAdds base damage to every registered tick across the contact window.
Armor Shred / CritSituationalWeakens elite defenses to amplify rapid hit sequences.

Flat damage increases scale well on the Saw Ball because the bonus applies to every individual tick. However, without sufficient velocity, the ball loses rotational speed upon contact and drops into the lower gutter before finishing the target.

Executing the Wall-Pin Technique

Firing the Saw Ball into an open arena yields respectable damage, but instantaneous kills require trapping the ball between the boss and a solid obstacle.

Follow these steps to set up the rebound trap:

  1. Hold fire during open movement: Do not launch the Saw Ball while the boss occupies the center of the pit. Wait for its movement cycle to bring it near a side wall or corner.
  2. Identify the rebound gap: Locate the narrow space between the boss's rear collision box and the adjacent arena wall.
  3. Aim diagonally into the pinch point: Shoot at a diagonal angle into the gap rather than aiming directly at the center of the boss.
  4. Trigger the bounce loop: Entering the pinch point forces the ball to ricochet rapidly between the wall and the boss, registering repeated collision ticks at point-blank range.

Wave Management and Workshop Progression

The Saw Ball's narrow focus makes it poor at handling spread-out waves across the pit. Relying on it exclusively early in a run leaves your base vulnerable to attrition damage from standard minions.

  • Pair with wide-area clear: Bring crowd-control options such as the Lightning Ball or Firework Ball to clear trash mobs. This ensures minor enemies do not intercept the Saw Ball before it reaches the boss.
  • Apply debuffs first: Launch status-inflicting or armor-shredding balls before firing the Saw Ball so continuous ticks benefit from damage amplification.
  • Target key Workshop upgrades: Between runs, invest gold into base ball velocity, launch power, and reroll tokens to secure momentum perks consistently during your descent.
BALL x PIT icon

Free BALL x PIT Codes

Current active codes and how to redeem them.

View Codes
Sarah Williams

Sarah Williams

Sarah specializes in RPG and collection games, explaining team building, character growth, and beginner-friendly ways to avoid expensive early mistakes.