To clear Level 1110 in Block Out, prioritize matching visible three-piece color sets immediately while keeping at least two buffer tray slots empty at all times. Deadlocks on this stage occur when you pull isolated blocks into your dock without exposed board pieces ready to complete the set. Focus on clearing shallow outer columns first, opening blocked color gates, and counting pieces before committing to late-stage moves.
Opening Priorities and Move Order
Level 1110 features dense vertical stacks that bury key colors under mixed layers. Pulling blocks into your tray without immediate matches rapidly consumes capacity. Begin the stage with these prioritized actions:
- Clear Visible Trios First: Scan the board for colors that already show three unobstructed pieces on top of stacks. Tap all three consecutively so they clear out of your tray instantly.
- Uncap Shallow Outer Stacks: Focus on stacks containing only two or three total layers before touching deep central columns. Stripping shallower stacks reduces board clutter and reveals lower layers with minimal risk.
- Leave Isolated Singles: Do not pull single, off-color blocks sitting atop deep stacks if their matching partners are buried. Digging without an active match leaves useless pieces sitting in your tray.
- Clear Lanes to Inactive Gates: Direct matches toward stacks obstructing color gates. Unlocking an exit lane gives corresponding colors a direct removal path, reducing pressure on your tray.
Buffer Tray Management Rules
Your buffer tray acts as a holding dock, not a discard pile. Maintaining at least two empty slots provides the buffer needed to dig through two prerequisite pieces to grab an essential match.
| Open Buffer Slots | Threat Level | Required Action |
|---|---|---|
| 4 to 5 Slots | Low | Excavate deep stacks freely to reveal buried underlayers. |
| 2 to 3 Slots | Moderate | Pull only two-step sequences where the finishing piece is already exposed on the board. |
| 1 Slot | Critical | Stop all exploratory moves. Tap only the exact piece that clears an existing set in the dock. |
| 0 Slots | Terminal | Level failed. No moves remain unless an automatic match clears immediately. |
Mid-Game Stack Excavation and Gate Routing
Once the shallow stacks are cleared, progress through the center by peeling interlocked layers without filling your dock:
- Alternate Between Neighboring Stacks: When two central columns alternate colors, do not clear one column completely while ignoring the other. Alternate taps between them so matching colors enter the tray together and merge within one or two moves.
- Open Gate Thresholds: Remove blocks parked directly in front of color gates as early as possible. Once a lane to a color gate is open, matching blocks bypass tray limits or exit promptly upon entry.
Late-Stage Clean-Up
Late deadlocks happen when players assume the final few blocks will clear automatically. With fewer total pieces on the board, mistimed taps can still trap you:
- Check Tray Pieces Before Board Pieces: If your dock holds two pieces of a color, find and tap the final matching piece on the board before touching any other stack.
- Finish One Color at a Time: Clear entire remaining color groups sequentially rather than pulling mixed colors into your remaining slots.
- Verify Final Layer Orders: Even with only six blocks left, tapping three different colors into three open slots will cause an instant loss if the matching pieces sit underneath one another. Count the order of layers to ensure each tap directly triggers a match.
Free Block Out Codes
Current active codes and how to redeem them.
COMMUNITY
Player Comments
94 players commented on this guide.
Good guide for Block Out players. The strategy part was useful.
I tried this today and it worked better than my old setup.
This saved me time in the early game.
I wish I had read this before upgrading the wrong thing.