Dislyte Infinity Tower Floors 9 and 10: 5-Star Clear Guide

To achieve a 5-star clear on Infinity Tower Floors 9 and 10 in Dislyte and claim the Legendary Abilimon, you must build around continuous Action Point (AP) denial rather than raw burst damage. High-tier tower modifiers elevate enemy base stats and introduce severe retaliation triggers, making it critical to stop hostile units from taking turns. Success relies on keeping opposing combatants locked at zero Action Points while layering hard crowd control.

Establish an Action Point Denial Loop

Attempting to burst through upper tower floors at maximum star difficulty leaves your team exposed to lethal counter-mechanics and wipe conditions. The safest approach is establishing a turn-lock loop that systematically depletes enemy AP while layering disables.

• Prioritize AP depletion: Strip enemy meters team-wide before opposing combatants reach action thresholds.
• Stack hard disables: Layer multi-target Stun, Freeze, or Taunt behind your AP wipes to neutralize enemies that resist meter reductions.
• Control incoming damage: By denying active enemy turns, your squad bypasses restrictive stage hazards and incoming damage penalties entirely.

Floor 9 Turn Rotation and Wave Management

Floor 9 penalizes reckless skill usage and limits recovery. You must conserve high-impact control abilities at the end of each wave to ensure full readiness when the next wave begins.

1. Deploy your fastest controller first: Open Wave 1 by setting enemy Action Points to zero before hostile passives trigger.
2. Lock cleansers and immunity casters: Target secondary crowd control directly onto units capable of removing debuffs.
3. Stagger cooldowns on low-health targets: Do not use major AP wipe skills when only one or two weakened enemies remain.
4. Refill meters before transitioning: Finish stragglers with basic attacks so your primary crowd control abilities are off cooldown when entering Wave 3.
5. Strip accidental immunity: If a cleanser acts and applies team-wide immunity, use targeted buff dispels immediately to re-establish your control chain.

Floor 10 Boss Wave Target Priority

Floor 10 requires isolating high-threat minions before focusing down the main boss. Indiscriminate area-of-effect damage can trigger hostile retaliation passives from side units.

Keep total AP suppression on the entire field while focusing your direct attacks on side units with cleanses or retaliatory triggers. Once supporting minions are eliminated or permanently stunned, chip down the boss safely.

Invest Legendary Abilimon into Gaia (Sienna)

A base-level Gaia (Sienna) without ability upgrades struggles to sustain crowd control due to lengthy cooldown gaps. Upgrading her abilities with Legendary Abilimon creates a qualitative leap in performance, establishing her as a tier-zero PvE controller for high-floor clears.

• Cooldown reduction: Fully upgraded skills lower the downtime on her primary control spells, allowing her to cycle abilities in tandem with your squad's support rotation.
• Full AP resets: Her ability to clear 100% of enemy Action Points while granting team-wide Speed and Attack buffs swings the turn order decisively in your favor.
• Encounter consistency: Investing the required Abilimon stabilizes high-variance 5-star encounters into predictable, repeatable lockdown chains.

Relic Selection and Speed Tuning

Speed tuning determines whether your controller acts before enemy affixes can disrupt your squad.

• Relic sets: Run high-speed sets like Wind to guarantee the opening turn, or utility sets like Ocean to accelerate cooldown cycles during drawn-out waves.
• Primary relic stats: Equip Speed on Mui II to maximize turn frequency, and prioritize Accuracy on Mui I to overcome elevated enemy effect resistance.
• Turn order: Tune your primary AP controller to act first, followed immediately by secondary crowd control, defense reduction, and support buffers.