Doomsday: Odysseus Returns iOS Auto Healing and 500 Cap Setup

To heal wounded troops efficiently in Doomsday: Odysseus Returns after the 500-assist daily limit update, configure an iOS Switch Control recipe that heals in batches rather than single units. Sizing each batch to match the total reduction granted by your alliance assists allows you to clear wounded units quickly without burning your 500 daily assists on tiny unit counts.

How the 500-Heal Limit Changes Hospital Strategy

The 500-assist daily ceiling restricts how many times alliance members can speed up your infirmary per day. Previously, players could queue single-troop healing batches repeatedly to instantly clear hospitals at zero speedup cost. Under the 500-action cap, cycling single units burns through your daily allowance while leaving the bulk of your wounded army untreated.

Maximizing recovery requires calibrating each healing batch to the exact amount of time your alliance assists can remove:

• Each alliance assist cuts healing time by a fixed percentage (typically 1% of the base time) or a set minimum floor, influenced by VIP level and alliance technology.
• If your alliance provides enough assists to shave off 25 minutes of base time, your troop slider should be set to a 25-minute heal.
• If the batch exceeds the total assist reduction, the cycle halts until speedups or gems are used, breaking unattended automation.
• If the batch is too small, you waste your 500 daily assist triggers on fewer troops than your alliance could have cleared for free.

iOS Settings and Switch Control Setup

Native iOS Switch Control automates screen taps without third-party software or jailbreaking. Configure your device settings before recording gestures to prevent interface shifts and screen timeouts.

1. Accessibility Shortcut: Open Settings > Accessibility > Accessibility Shortcut and check Switch Control. This binds activation to a triple-click of the Side button or Home button.
2. Display Timeout: Go to Settings > Display & Brightness > Auto-Lock and select Never so the device does not lock mid-cycle.
3. Switch Setup: Go to Settings > Accessibility > Switch Control > Switches. Ensure a full-screen tap switch exists. If none is present, tap Add New Switch... > Screen > Full Screen > Select Item.
4. Create the Recipe: In the Switch Control menu, navigate to Recipes > Create New Recipe. Name the recipe, tap Assign a Switch..., choose Full Screen, and select Custom Gesture.

Recommended Automation Parameters

Use these baseline parameters when recording and running the touch cycle:

Step-by-Step Gesture Recording Flow

Position your base view over the infirmary or keep the hospital interface open before recording the custom gesture in iOS Settings.

1. Open the Infirmary: Tap the hospital structure or the medical cross icon to bring up the wounded roster.
2. Set Troop Count: Tap the slider increment buttons (or a fixed point on the slider bar) to select the number of units that produces your target assist duration.
3. Confirm Treatment: Tap the Heal button to start the timer.
4. Request Help: Tap the alliance help icon over the building or inside the interface to broadcast the assist request.
5. Wait and Save: Pause for two to three seconds to account for network latency, then tap Save in the top right corner.

Once saved, return to the Switch Control menu, tap Launch Recipe, and select your new healing recipe.

Running and Stopping the Loop

Open Doomsday: Odysseus Returns, navigate directly to your hospital screen, and triple-click the Side or Home button to enable Switch Control.

• Queuing Runs: Every tap on the screen queues one execution of your recorded gesture. Tapping the screen 10 times queues 10 consecutive cycles.
• Staying Within the Cap: Track your queued taps to ensure you do not exceed your remaining daily assist limit.
• Stopping Execution: If the interface shifts or you need to cancel queued taps immediately, lock the device using the physical power button to terminate Switch Control.