Dynasty Legends 2 GameSir G8 Galileo Android Setup Guide

Dynasty Legends 2 lacks native controller support on Android, meaning the GameSir G8 Galileo cannot control your officer out of the box. To play with physical sticks and buttons, you must connect the controller via USB-C and use the GameSir companion app's G-Touch screen-mapping mode to bind physical inputs directly over the game's on-screen virtual buttons.

1. Connect the G8 Galileo to Your Android Device

The GameSir G8 Galileo connects directly through a built-in Type-C plug rather than Bluetooth, drawing power directly from your phone.

1. Remove bulky cases: If your phone case prevents the Type-C port from seating completely into the right-side connector, remove it before mounting.
2. Mount the phone: Extend the controller's spring-loaded bridge, insert your Android device, and slide the Type-C port firmly onto the plug.
3. Switch to G-Touch mode: Check the mode LED on your controller. Set the device to G-Touch (touch-mapping) mode using the Mode button combination outlined in your hardware manual until the indicator LED reflects touch-mapping input.
4. Grant permissions: Accept the Android system prompt allowing the GameSir app to access the connected USB accessory.

If your device runs low on power during extended play sessions, connect a charging cable to the pass-through Type-C charging port on the lower-right grip of the controller.

2. Configure the Touch-Mapping Overlay

Because Dynasty Legends 2 relies entirely on touch inputs, the GameSir companion app provides a floating overlay to translate physical inputs into screen taps.

1. Install and launch the GameSir app on your Android device.
2. Grant the app required system permissions, including Floating Window / Display over other apps and Accessibility access.
3. Add Dynasty Legends 2 to the GameSir app library and launch the game through the GameSir launcher.
4. Enter a training arena or a solo campaign stage so the full combat user interface is visible on screen.
5. Tap the floating GameSir icon to open the mapping editor.
6. Drag the virtual left stick over the on-screen movement joystick.
7. Tap the screen to spawn mapping icons for your attacks, dodges, and skills, then drag each icon directly over its corresponding on-screen combat button.
8. Save the layout as a profile for Dynasty Legends 2.

Recommended Combat Button Layout

A balanced layout places high-frequency actions on the face buttons while assigning cooldown skills and hero swaps to the shoulder buttons:

For directional abilities that require aiming, open the mapping editor, select the assigned button (such as RT or RB), and set its properties to associate with the right analog stick. Holding that button will allow the right stick to aim the targeting reticle, executing the attack upon release. For wide-cleave melee attacks with automatic targeting, keep the button set to a standard instantaneous tap.

Troubleshooting Common Setup Issues

• Buttons Tap Off-Center: If virtual taps miss the UI buttons after loading into combat, verify that your phone's screen resolution has not shifted. Lock your display to a fixed resolution and aspect ratio in your Android display settings so overlay coordinates remain aligned.
• Controller Drops Connection Mid-Battle: Android power management may close background services. Open Android's App Info for the GameSir app, select Battery, and change the setting to Unrestricted.
• Movement Drifting: If your officer moves without input, open the GameSir app's hardware calibration menu and increase the left stick inner deadzone by 3% to 5% to neutralize resting stick drift.