To clear Level 296 in Parking Loop, release unobstructed perimeter stalls first, time each car's entry to avoid moving traffic on the circuit, and wait until lead vehicles clear the merge junction before releasing trapped tandem cars behind them.

Collisions cause an instant level failure. Managing the flow requires clearing outer paths to create visual space, then methodically clearing interior bays into open gaps.

Clear outer boundary stalls before touching interior vehicles. Freeing unobstructed outer cars creates room on the board and eliminates visual distractions when timing tighter interior merges.

  1. Lead boundary stalls: Tap corner vehicles that point directly toward the open exit lane first. These cars leave the circuit almost immediately without lingering on the loop track.
  2. Opposing outer lanes: Release vehicles along the opposite exterior edge. Alternate sides so cars enter the roadway in staggered intervals rather than clustering together.
  3. Aisle flankers: Tap cars parked at the edges of internal rows that lead straight into open loop bends.
  4. Interior tandem leads: Release the front vehicles blocking interior bays once the outer loop has breathing room.
  5. Interior tandem rear cars: Tap the rear vehicle only after its lead car has fully cleared the stall's merge junction.

Merge Timing and Gap Requirements

Cars on the circuit travel at a fixed speed and retain right-of-way until reaching the exit. To prevent a collision, tap a waiting car only when there is sufficient distance between oncoming vehicles.

Traffic SituationRequired Loop GapActionRisk Level
High Loop Density1.5 to 2 car lengthsHold parked car until the passing cluster clearsHigh
Moderate Spacing1 full car lengthTap immediately after the passing car's bumper clears the stall thresholdModerate
Clear Circuit TrackOpen track aheadRelease lead car, followed promptly by an adjacent clear vehicleLow
Tandem Rear Car Launch1.5 car lengthsWait until the forward car completes its turn and clears the junctionHigh

The most reliable visual cue is to wait until an oncoming vehicle completely passes your stall's front bumper, then tap your car so it slips into the trailing gap.

Managing Tandem Stalls

Interior bays contain tandem setups where a rear car cannot move until the front car leaves. Tapping a blocked vehicle while the front car is stationary triggers an inactive tap warning.

  • Do not double-tap tandem bays: Tapping the rear car immediately after launching the lead car causes both vehicles to enter the loop in rapid succession. This frequently leads to the rear car rear-ending loop traffic or clipping the turning bumper of the front car.
  • Confirm junction clearance: Allow the front vehicle to finish its turn into the circuit and verify that another gap exists on the main loop before releasing the rear vehicle.

Common Mistakes to Avoid

  • Tapping adjacent stalls simultaneously: Never release two side-by-side cars at the same moment, as their exit angles converge on the same entry tile.
  • Ignoring downstream loop traffic: Before tapping any vehicle, look ahead along the circuit track. A car released seconds earlier may be circling back toward the merge point where you intend to launch a new vehicle.
  • Rushing interior exits: Interior bays have narrower clearance angles. Prioritize waiting for an open loop over clearing the lot quickly.
Parking Loop icon

Free Parking Loop Codes

Current active codes and how to redeem them.

View Codes
Emily Johnson

Emily Johnson

Emily writes practical mobile strategy guides with a focus on resource planning, base progression, and the early decisions that shape a long-term account.