To clear Level 361 in Parking Loop, empty unobstructed perimeter stalls first to establish open line-of-sight and merging space, then release pinned interior vehicles one at a time into trailing traffic gaps. Rushing vehicles into the main circuit or releasing tandem rows in quick succession causes collisions at sharp feeder junctions.
Step-by-Step Level 361 Clearing Order
Clear the lot from the outside in to prevent gridlock along the continuous looping transit lane:
- Identify open exterior stalls: Scan the lot fringe for vehicles whose exit paths directly meet the main loop without obstruction from neighboring cars.
- Stagger perimeter releases: Wait for an oncoming circulating car's rear bumper to pass the feeder junction, then tap the exterior car to merge into the empty trailing pocket.
- Expose tandem rows: With perimeter stalls emptied, release the front cars blocking the interior grid into wide multi-car gaps.
- Clear pinned rear vehicles: Allow each front car's rear bumper to fully clear the junction before queuing its corresponding rear vehicle.
- Drain converging feeder lanes: Alternate releases between intersecting interior lanes until all vehicles leave the board through the exit gate.
Merge Timing Cues for Continuous Traffic
Vehicles in the moving loop travel at uniform speeds, leaving narrow clearance pockets. Because a slight delay occurs between tapping a parked vehicle and its bumper reaching the track, tapping while an oncoming car approaches the junction results in a crash. Tap immediately after a circulating vehicle passes the ramp entrance to slot into the space behind it.
| Merge Scenario | Vehicle Action | Correct Timing Cue | Collision Risk |
|---|---|---|---|
| Single Outer Car | Merge directly into loop | Tap as circulating car passes ramp | Low |
| Tandem Front Car | Expose pinned rear vehicle | Release during wide multi-car gap | Moderate |
| Tandem Rear Car | Deep stall follow-up merge | Wait for full vehicle length clearance | High |
| Converging Junction | Dual lanes sharing one entry | Alternate releases between feeder lines | Critical |
Dismantling Nested Interior Bays
Interior stalls are organized in tandem rows where rear cars remain completely pinned until the front car leaves. Do not tap both cars in rapid succession; the rear car will rear-end the lead vehicle while it negotiates the turn.
Treat each tandem stall as a separate release cycle. Tap the lead vehicle and verify that it has completely turned onto the outer loop before committing the second car. If circulating traffic blocks the second vehicle's entry window, keep it parked until the next gap appears. Parking Loop imposes no penalty for waiting, so let congested traffic clear through the exit gate before releasing the final vehicles.
Free Parking Loop Codes
Current active codes and how to redeem them.
COMMUNITY
Player Comments
149 players commented on this guide.
The explanation is clear, especially for beginners.
This helped me understand strategy much better.
I tried this today and it worked better than my old setup.
This guide answered the exact question I had.