Rotate Rings Level 132 Solution and Ring Alignment Order

To clear Level 132 in Rotate Rings, align the ring openings from the inside outward toward the upper-right quadrant (approximately 45 degrees). Locking the innermost layer first gives you a stationary reference point, allowing you to bridge the middle and outer rings into a single continuous exit channel without trapping the center piece behind solid barrier walls.

Step-by-Step Alignment Order

Working from the deepest circle to the exterior perimeter prevents backtracking and avoids the visual clutter caused by rotating outer segments prematurely.

1. Set the inner ring: Drag the innermost ring counter-clockwise until its open notch rests in the upper-right quadrant (45°).
2. Connect the middle ring: Turn the middle ring clockwise until its interior opening meets the inner ring's notch. Confirm that its outward-facing opening also points toward the upper-right exit corridor.
3. Verify the transition: Check that the channel between the inner and middle rings is completely clear. If a solid barrier edge cuts across the opening, make a slight counter-clockwise adjustment to square the passage.
4. Open the outer ring: Rotate the exterior ring clockwise or directly into position until its exit gap aligns with the middle layer. Once all three openings form an unbroken line, the central core exits through the corridor, completing the stage.

Preventing Input Errors and Drift

Level 132 packs narrow openings closely together, which increases the risk of accidental moves and input collisions on touchscreens:

• Touch near the outer rim: The touch zones of adjacent rings overlap near their seam lines. Place your finger firmly along the outer edge of whichever ring you intend to rotate to prevent spinning two tracks at once.
• Avoid fast flicks: Quick swipes carry momentum that can cause a ring to drift past its target position. Use controlled, deliberate drags so each notch stops precisely on center.
• Do not start with the outer ring: Aligning the large exterior ring first often hides the positioning of the inner barriers, forcing blind guesswork on the central tracks.
• Restart if desynchronized: If an accidental double-input leaves multiple rings offset at conflicting angles, resetting the level is faster than recalibrating all three layers individually.