Aniimo Infinite Ultimate Water Build and Rotation Guide

To run an infinite Ultimate Water build in Aniimo, pair a primary burst attacker such as Nightstar with fast-hitting off-field energy supports, then execute a strict rotational sequence to recharge your gauge before the previous burst cooldown ends.

This engine works by linking active skill hits against debuffed targets directly to rapid energy generation. When secondary skills continuously deploy multi-hit effects, your primary attacker recovers energy fast enough to cast Ultimates on cooldown, avoiding basic attack downtime and maintaining continuous combat pressure.

Team Composition and Roles

The build requires three complementary roles to keep the energy loop moving without interruptions.

Nightstar serves as the core carry for this setup because the creature converts pooled energy into wide-area Water burst hits with high base multipliers. The remaining team slots should not compete for active field time; instead, prioritize supports that drop persistent hazards or projectile attacks that generate particles while off the field.

Ultimate Rotation Sequence

Executing skills out of order will break the loop and force you to wait through long energy recharge pauses. Follow this sequence to maintain continuous skill uptime:

1. Apply Water Vulnerability: Start by using your secondary support's lingering skill to inflict elemental vulnerability on the target.
2. Deploy Battery Skills: Cast your energy catalyst’s active abilities to seed the battlefield with energy particles and activate resource regeneration passives.
3. Trigger the Primary Ultimate: Switch immediately to your main carry (such as Nightstar), confirm the energy gauge is full, and cast the Ultimate to hit boosted targets.
4. Collect Lingering Energy: Fire the main carry's innate active skill immediately after the Ultimate animation concludes to absorb active particles on the field.
5. Refresh Utility and Reset: Swap to your utility support to refresh cooldown buffs and vulnerability debuffs, then begin the cycle again from step one.

Stat Priorities

To reach burst damage spikes exceeding 220,000, build your roster around energy consistency first, then maximize burst multipliers.

• Elemental Burst Damage and Water Damage Bonus: Prioritize this multiplier on your main carry. Because the rotation relies on continuous Ultimate casts, burst scaling provides higher overall returns than flat attack or basic attack bonuses.
• Energy Recharge: Stack this stat primarily on your energy catalyst and utility support. Your main carry only requires enough recharge to guarantee a full meter within a single five-step rotation.
• Critical Rate and Critical Damage: Invest in critical stats on your primary carry once energy benchmarks are met to scale the multi-hit ticks of the Ultimate.

Encounter Hazards and Adjustments

Mobile enemies and elemental resistances can disrupt the timing required to keep your meter full:

• High-Mobility Bosses: Bosses that leap away or become untargetable cause deployed skills to miss, halting particle flow. Delay your catalyst abilities until the target completes its movement pattern to prevent wasted resources.
• Water-Resistant Targets: Enemies with Water shields or inherent elemental resistance significantly reduce your damage output. Bring resistance-shredding debuffs in your utility slot to bypass these defenses.
• Animation Vulnerability: While Ultimate animations provide temporary invulnerability frames, your carry remains exposed the moment the animation finishes. Avoid triggering bursts directly on top of persistent ground hazards.