CubeAway Level 34 Guide: How to Beat the Hard I-Tower

To beat Level 34 in CubeAway, dismantle the horizontal caps at the top and bottom of the I-tower before tapping any blocks in the central column. Clearing the unblocked outer corners first removes the physical overhangs that trap upward- and downward-pointing arrows inside the central pillar.

Level 34 I-Tower Structure and Collision Traps

Level 34 features a Hard-rated "I-tower" layout resembling an I-beam: a tall vertical stem sandwiched between wider top and bottom platforms. This stage features tightly clustered arrows on every face, creating severe spatial congestion.

The primary obstacle is overhang interference:

• Upward- and downward-pointing arrows in the central column cannot exit while the top and bottom caps remain in place.
• Lateral arrows inside the middle pillar will collide with outer cap edges if launched prematurely.
• Inward-pointing perimeter blocks trap adjacent cubes until outer corners are removed.

Solving the puzzle requires dismantling the structure from the outer extremities inward to keep exit trajectories clear.

Step-by-Step Clearing Sequence

Work symmetrically between the top and bottom platforms before addressing the dense central column.

1. Strip the Horizontal Flanges

Begin by rotating the puzzle to inspect the wider top and bottom platforms.

1. Tap outward-pointing corner blocks: The outer corners of the top and bottom caps have completely unobstructed exit trajectories leading into empty space. Tap these first to start loosening the grid.
2. Peel the rim inward: Removing the corners unblocks neighboring edge blocks pointing laterally or outward. Clear these perimeter blocks along all four sides of both caps.
3. Expose the stem connectors: Continue peeling the cap edges inward until only the central connector blocks joining the caps to the vertical pillar remain.

2. Dismantle the Vertical Stem

Once the overhangs are gone, shift focus to the dense central pillar.

1. Remove lateral outer blocks: Rotate around the pillar and clear arrows pointing horizontally outward. Because the cap overhangs are gone, these blocks can escape cleanly into open space.
2. Distribute removals evenly: Strip blocks from all four vertical faces rather than clearing only one side. Circling the tower maintains visibility and uncovers buried arrow directions evenly.
3. Release the vertical core: With the outer jacket removed and the platforms cleared, the remaining central cubes will point upward or downward. Tap these vertically aligned blocks to send them straight out through the clear space above and below the tower.

Camera Angles and Common Mistakes

Level 34 hides several exit-ready blocks beneath its structural lips. Use active camera rotation to avoid common traps:

• Inspect the overhang undersides: Rotate the camera upward to look directly at the bottom surface of the top cap. Cubes tucked under this rim often point downward or outward and are invisible from standard side views.
• Inspect the lower platform surface: Tilt the view downward to examine the upper face of the bottom cap for upward-pointing blocks that can be safely freed.
• Verify flight corridors at 45 degrees: Before tapping a block in the central stem, tilt the camera into an isometric 45-degree angle. Trace the arrow's entire flight path across the screen to ensure it will not clip a remaining block on the opposite side.
• Avoid premature vertical launches: Tapping an upward-pointing arrow in the stem while the top platform still has overhang blocks causes a collision, resulting in a failed move. Keep both horizontal caps stripped down before triggering vertical core arrows.