Match Factory! Level 369 Guide: Target Priority and Tray Management

To beat Level 369 in Match Factory!, clear fully visible target triplets from the surface of the pile before attempting to dig for partially hidden pieces. Managing your bottom holding tray is the primary win condition: pulling mismatched items quickly consumes your seven available slots, leading to an immediate loss if the tray fills completely.

Surface Target Priority

Level 369 requires collecting designated target items shown in the top objective bar before the level timer runs out. Non-objective clutter fills the board, burying targets and complicating selections. Begin the level with targeted surface clearing:

• Collect immediate triplets: Scan the top layer for three matching, unobstructed objective items. Tapping all three in succession clears them instantly without tying up tray space.
• Avoid premature single picks: Do not tap an isolated target item if its matching pairs are buried under deep piles. Leaving it on the board preserves your tray capacity.
• Clear blocking items only when necessary: If two matching targets are accessible but the third is trapped beneath an obstacle, pick the blocking item only if you have enough open tray slots to absorb the temporary clutter.

Bottom Tray Slot Management

Your bottom tray holds a maximum of seven items. Every unmatched item you tap remains in the tray until its triplet is completed. Maintaining a buffer of open slots ensures you can maneuver around dense piles without failing the level.

To minimize risk, avoid holding more than two incomplete item sets in your tray at the same time. If your tray holds two different unmatched items, do not select a third distinct type unless you can immediately tap all three matching pieces in sequence to clear it.

Physics Shifts and Digging Strategy

Match Factory! uses real-time physics, causing surrounding items to roll, slide, and settle when pieces are pulled from the pile. Use this behavior to access buried objectives:

1. Identify the blockage: Locate the specific clutter item pinning down a required objective.
2. Check your tray buffer: Verify you have at least three open slots before picking up non-target obstacles.
3. Observe the shift: After removing an obstacle, pause briefly to let the pile settle. Tumbling debris frequently exposes missing target items on the flanks or top surface of the pile.

Pacing and Booster Utility

Frantic tapping increases misclicks, which rapidly fills tray slots with unintended items. Maintain steady pacing by pausing whenever your tray reaches four items to re-evaluate the board.

If your tray becomes clogged near capacity and no visible matches remain on the board, utilize utility boosters:

• Vacuum: Automatically gathers and clears target items to instantly free up congested tray slots.
• Spring: Clears away obstructive clutter, uncovering buried target pieces without taking up tray space.
• Fan: Shuffles the entire board, loosening tight clusters and bringing buried targets to the surface.

Reserve boosters for critical moments when the timer is low or when only one or two tray slots remain open with no immediate matches visible.