Tiles Survive!! Labor Fest Chapter 2 Level 10 Guide

To beat Chapter 2 Level 10 of the Labor Fest event in Tiles Survive!!, position a durable frontline defender at the primary choke point, switch high-impact abilities to manual activation, and clear the boss's armored escorts before triggering your single-target burst skills.

Required Team Setup

The encounter combines early mob swarms with a heavily guarded end-stage boss. Splitting your squad across four dedicated roles ensures the lane stays contained while maintaining enough damage to defeat the boss before your perimeter falls.

Preliminary Wave Management

Surviving the preliminary waves requires manual cooldown management. Relying on auto-cast often causes heroes to waste long-cooldown ultimate skills on weak stragglers immediately before major threats appear.

1. Disable Auto-Cast: Take manual control of high-impact crowd control and single-target burst skills before starting the stage.
2. Rely on Passive Clearing: Use basic attacks and passive area-of-effect traits to defeat the light infected clusters during the opening waves.
3. Use Minor Skills Mid-Phase: As enemy density increases halfway through the preliminary horde, trigger minor area abilities to keep standard mobs from overwhelming your frontline anchor.
4. Hold Ultimates for the Boss: Allow basic attacks to clean up the final remaining minions of the pre-boss wave. This ensures cooldowns reset and burst abilities are fully charged when the boss enters.

Defeating the Boss and Escorts

The chapter boss enters alongside armored escort units that divert single-target skills away from the main target. Rushing all abilities immediately upon their arrival will dilute your damage across the escorts.

• Anchor the Entrance: Cast your primary crowd control slow or stun as soon as the boss crosses into your choke point. This clumps the boss and escorts together in the center of the lane.
• Eliminate the Escorts First: Fire your secondary area-of-effect abilities into the clump. This strips away the surrounding escorts and chips down the boss's outer protection.
• Unload Single-Target Burst: Once the escorts fall, focus all single-target ultimates directly on the boss.
• Maintain Control Chains: Keep slow effects active to prevent the boss from pushing through the defender. If the boss begins an attack windup against your front line, trigger an interruption or defensive shield skill to absorb the hit.

Troubleshooting Stage Failures

If your defense fails before completing the stage, adjust your tactics based on where the run breaks down:

• Infected leak past the perimeter: Pull your frontline anchor slightly backward toward a narrower choke point to close off the side paths and stop fast runners from slipping by.
• Crowd control wears off too quickly: Stagger your disabling abilities instead of stacking them. Wait until an active slow or stun is about to expire before casting the next control skill.
• Single-target skills hit the wrong targets: If your burst heroes target secondary adds instead of the boss, delay your area-clearing abilities until adds appear so the lane is immediately cleared for boss lock-on.
• The boss survives with high health: If you clear the mobs easily but run out of time or health against the boss, replace a redundant tank or support unit with an additional single-target damage dealer.