Bus Traffic Fever! Gridlock Guide: How to Sequence Buses

To prevent gridlock in Bus Traffic Fever!, scan the parking lot for buses with direct, unobstructed paths to the exit before tapping any vehicle. Moving buses without verifying their entire exit route risks trapping surrounding vehicles and stalling progress in high-density levels.

Priority Checklist for Vehicle Release

Always clear buses that have an immediate line to the exit gate or those occupying lanes that restrict multiple adjacent vehicles. Removing these key bottleneck vehicles creates space to maneuver deeper traffic.

• Exit Proximity: Release vehicles closest to the exit first to open up initial space.
• Bottleneck Lanes: Target vehicles blocking the largest number of trapped buses to trigger chain-reaction openings.
• Single-Lane Focus: Clear one lane entirely rather than spreading moves across the board. Fully cleared lanes act as buffer zones for maneuvering remaining buses.

Spotting Path Obstructions and Repositioning

Before committing a turn, look two to three steps ahead to ensure moving a bus does not block an exit route for another essential vehicle. Cross-referencing traffic positions helps avoid deadlocks:

• Intersection Overlap: Confirm the bus does not need to cross a lane blocked by a stationary large vehicle.
• Exit Gate Access: Verify that the primary gate line is clear of stationary vehicles requiring separate moves.
• Vehicle Proximity: Avoid parking a bus in a spot that blocks a higher-priority vehicle from reaching the exit.

When the grid becomes crowded, use empty tiles or low-traffic lanes as temporary staging areas. Moving a vehicle out of a main lane into a temporary holding spot allows you to resequence the board and free high-priority exit routes.

Recognizing Deadlocks and Resetting

If a board reaches a state where remaining moves cannot open an exit path, the level has hit a deadlock. This usually stems from an incorrect initial vehicle sequence. Stop making random moves and restart the stage, using your knowledge of which bus originally caused the block to adjust your starting release order.